Welcome to the official website of Zhangjiagang samsara Machinery Co., Ltd!

Open up the future

Automatic conveying system

集中供料系统

Hotline

+86 18962249117

新闻banner

News Center

current position: Home > News Center > Industry News

contact usContact Us

Zhangjiagang Senmeirui Machinery Co., Ltd.

Contact: Mr. Li

Mobile: +86 18962249117

Tel: +86 15150202228

QQ: 121174223

Website: www.smrjx.cn

Email: roger@smrmach.com

Address: No. 60-1, Jinzhong Road, Jinfeng Town, Zhangjiagang City, Suzhou City, Jiangsu Province

What problems should we pay attention to when using the automatic feeding system?

2023-01-04 09:11:46
times

Two problems to be paid attention to when using the automatic feeding system:

When using the automatic feeding system, we need to pay attention to the following two issues: whether the feeding amount at the feeding port is reasonable.

Whether the loading and unloading parameters are reasonable.

Whether the feeding amount at the feed inlet is reasonable:

Many destruction equipment uses manual elastic tube to suck materials. In order to facilitate the operation, the elastic tube is directly inserted into the material barrel or ton bag. The suction port of the elastic tube is compressed by the tight material, and the strong negative pressure pulls the full material away. In fact, the damage to the fully automatic feeding machine is very large, and it is easy to block the pipeline. The correct method is to form a certain air-material mixing ratio between the material and the air at the suction port (that is, the elastic tube can be placed on the material surface), and evenly flow into the feeding machine under the promotion of the air flow. At this time, we need to plan the elastic tube with the function of replenishing qi. If the material is overstocked for a long time, it may be very hard. At this time, it is necessary to install an oscillator on the elastic tube to shock small lumps of material.




The loading and unloading time parameters are unreasonable:

Due to the inability to install a material level machine in the silo, the automatic loading machine can only be operated at all times for professional use. So how to set the time parameters for * times using the automatic feeding machine? Whether the manufacturer of the fully automatic feeding machine can provide guidance? The setting of the feeding and unloading time is actually very simple. In the initial use, set a small time first, and then gradually increase according to each feeding position. When the time of reaching the material level and reaching the feeding mouth, then subtract one second is the reasonable time. The feeding time is to ensure another second after feeding. This has two advantages:

Too high material level will cause great damage to the filter element. This is why some of our customers can use a filter element for two years or half a year.

Each time the material can be put clean, and the feeding valve will not appear when it is closed. The feeding valve will damage the sealing ring of the frequent operation of opening and closing five or six times per minute.



Recently Viewed: